Hi All, I am working on porting linux kernel 3.4 to an arm926-ejs based fpga board. After the kernel bootup, in the command prompt when i am using the command "ps -l "..i am getting the following *sh-4.2# ps -l* *Unknown HZ value! (744514) Assume 100.* * * * * *F S UID PID PPID C PRI NI ADDR SZ WCHAN TTY TIME CMD* *0 S 0 51 1 0 80 0 - 443 wait ttySAC0 00:00:12 sh* *0 R 0 56 51 0 80 0 - 297 - ttySAC0 00:00:04 ps* * * * * The issue i am facing is *"I configured the jiffies for 25Hz,still it is assuming 100hz."* Is this problem related to the filesystem i am using. I am using ".ext2" filesystem build from buildroot. The option set in buildroot for creating filesystem are as mentioned below: *(3.4) linux version * *uClibc C library Version (uClibc 0.9.33.x)* *Binutils Version (binutils 2.21.1)* *GCC compiler Version (gcc 4.7.x)* Will this issue be fixed If i use glibc nstead of uclibc in buildroot ? Thanks, Karthik.