Hi All,<div><br></div><div><br></div><div>I am working on porting linux kernel 3.4 to an arm926-ejs based fpga board.</div><div><br></div><div><br></div><div>After the kernel bootup, in the command prompt when i am using the command &quot;ps -l &quot;..i am getting the following </div>

<div><br></div><div><div><b>sh-4.2# ps -l</b></div><div><b><font color="#ff0000">Unknown HZ value! (744514) Assume 100.</font></b></div><div><b><br></b></div><div><b><br></b></div><div><b>F S   UID   PID  PPID  C PRI  NI ADDR SZ WCHAN  TTY          TIME CMD</b></div>

<div><b>0 S     0    51     1  0  80   0 -   443 wait   ttySAC0  00:00:12 sh</b></div><div><b>0 R     0    56    51  0  80   0 -   297 -      ttySAC0  00:00:04 ps</b></div></div><div><b><br></b></div><div><b><br></b></div>

<div>The issue i am facing is <b>&quot;I configured the jiffies for 25Hz,still it is assuming 100hz.&quot;</b></div><div><br></div><div>Is this problem related to the filesystem i am using.</div><div><br></div><div>I am using &quot;.ext2&quot;  filesystem build from buildroot.</div>
<div><div><br></div><div>The option set in buildroot for creating filesystem are as mentioned below:</div><div><br></div><div><b>(3.4) linux version  </b></div><div><b>uClibc C library Version (uClibc 0.9.33.x)</b></div></div>
<div><b>Binutils Version (binutils 2.21.1)</b></div><div><b>GCC compiler Version (gcc 4.7.x)</b></div><div><br></div><div><br></div><div>Will this issue be fixed If i use glibc nstead of uclibc in buildroot ?</div><div><br>
</div><div><br></div><div><br></div><div>Thanks,</div><div>Karthik.</div><div><br></div><div><br></div><div><br></div><div><br></div><div><br></div><div><br></div><div><br></div><div><br></div><div><br></div>