Hi, I've got a question regarding FlexSPI controller available on e.g imx8mm or ls1028/2160 boards. To not waste your time here is tldr; Does spi-nxp-fspi controller (and Linux driver) support simultaneous read/write transactions? More details here: I have two boards, the first one is LS1028a, and the second one is Hilsher netX90 and I need to connect these two over SPI. The only available SPI controller I have on my board is FlexSPI. From what I've found in the documentation by using LUT sequences I should be able to adapt it to the protocol that is needed by netX90. There is just one problem: netX immediately sends some status information (1 status byte followed by 3 undefined bytes) once the master starts clocking, which results in simultaneous transfer on both MOSI and MISO lines. Eg when I want to issue a read operation on netx, I send the following byte stream:(1 byte cmd, 3 bytes addr, 1 byte length) MOSI: 0x80 | 0x12 0x34 0x56 | 0x4 MISO: 0x11 | 0xXX 0xXX 0xXX | data[0]... data[3] As you can see the status byte - 0x11 (followed by some undefined 3 bytes) is immediately sent over the MISO line. Then, data[0]...data[3] is actual data that was requested to fetch. I tried to use spi-mem framework that is supported by spi-nxp-fspi controller driver, but it does not support handling simultaneous transfer thus at the end of the SPI transaction I ended up with a rx buffer consisting of data[0]...data[3] only. Kindly asking for any advice. Unfortunately, there is no way to use a traditional SPI controller in this case, as all of them are used for other purposes. BR Patrick