Hi everybody. I know that there are some GPIO lines that needs sleeping to get actived/deactived, this is why we have the gpio_cansleep_*() functions. So, I'm planing using the Microchip MCP2210 which act as USB->SPI bridge. The problem is that the SPI slave device has two extra lines, one for IRQ and another for enabling the chip (CE). Since MCP2210 has GPIOs too I was wondering about wiring IRQ and CE to some GPIO lines and using it as general GPIO at host. My concern is if the IRQ line through USB, if it would sleep, if would be possible to use it as IRQ!? The summarized setup is this HOST -> usb bus -> MCP2210 <-- SPI bridge <- slave device spi lines '- GPIO 0 <- slave device IRQ line '- GPIO 1 <- slave device CE line Any help is appreciated, Best regards and thanks in advance! -- "Do or do not. There is no try" Yoda Master