On Fri, Nov 04, 2022 at 06:04:15PM +0900, Chan Kim wrote:
Hello linux experts and newbies,
I have ported linux on our arm64 fpga board. Both 5.10.0 and 5.15.xx works ok with minimal config. I have run a simple application and timed the processing time using clock_gettime function. It felt like it took almost 2.3 seconds but the program say it took only 0.36 seconds. Here is how I did it in the application.
Hello, while I'm by no means an authority on kernel code and the board you are developing for I did spot some problems with your provided example code.
Int main() {
struct timespec start, stop; float exec_time_sec, exec_time_nsec;
//check start time if (clock_gettime(CLOCK_REALTIME, &start) == -1 ) { perror ("clock_gettime"); exit(EXIT_FAILURE); }
CLOCK_REALTIME is defined as "wall time" in `man clock_gettime` so it should not be impacted by the CPU frequency.
Do something... (calculate fibonacci value for 1 ~ 30)
//check end time
if (clock_gettime(CLOCK_REALTIME, &stop) == -1 ) { perror ("clock_gettime"); exit(EXIT_FAILURE); }
//Normalize to mili second exec_time_sec = (float)(stop.tv_sec - start.tv_sec);
You are not converting seconds to milliseconds here but in the printf call below you are asuming it's the same time unit.
exec_time_nsec = (float)((double)(stop.tv_nsec - start.tv_nsec)/(double)BILLION);
1 millisecond is 0.000001 nanoseconds. So you want MILLION here. Also, it's a lot of casting.
printf("Execution time : %f sec\n", exec_time_sec + exec_time_nsec);
return 0; }
I used u-boot program for loading linux kernel and the u-boot program sets the CNTFRQ_EL0 register with 5000000. (which is 5MHz, I heard the system clock runs at 5MHz in the board). The description of the register in armv8 arch manual says :
This register is provided so that software can discover the frequency of the system counter. It must be programmed with this value as part of system initialization. The value of the register is not interpreted by hardware.
I tried setting the CNTFRQ_EL0 with 20Mhz, expecting the execution to be displayed 4 times shorter but it is the same! I couldn't find how linux uses clock_gettime. How can I solve this problem? Any advice will be deeply appreciated.
Thank you!
Chan Kim
I would suggest that you have a read through `man clock_gettime`. After fixing your code. In particular you might be interested in the actual CPU time clocks. That said. I'm not sure these are the system calls you should be looking at. Br, Linus Probert
_______________________________________________ Kernelnewbies mailing list Kernelnewbies@kernelnewbies.org https://lists.kernelnewbies.org/mailman/listinfo/kernelnewbies