I have a set of drivers that I would like to upstream. These are primarily MFD style drivers supporting Cisco-8000 FPGAs. The devices can be instantiated through multiple top level drivers, which provide the access mechanism for the MFD driver. For example, an FPGA can be accessed via PCI, or via i2c, or via SLPC, or via P2PM (a point-to-point interface). We currently build these drivers out of tree, under a single directory drivers/cisco. I note that existing drivers are spread out across the kernel tree, sometimes by bus (pci, i2c), sometimes by function (gpio, net/mdio, spi), and sometimes under the generic mfd. I would like to start the upstream review process for our drivers, but first want to get recommendations on the source code layout. Is it permissible to keep a top level directory such as drivers/cisco to organize our code? It is not only the source code that is affected, but also provides a central place for Kconfig entries. Our FPGAs have multiple logical blocks, each of which is handled by a different MFD driver, e.g. i2c controllers, gpio controllers, spi controllers, mdio controllers. There can be multiple instances of each block as well (so multiple MFD devices are instantiated for each driver). And of course, there can be multiple FPGAs in a system, each with different combinations of logical blocks. The drivers themselves are pretty specific to our FPGAs, thus it makes sense to use Kconfig to select a hardware platform to automatically select the set of MFD drivers (and top level bus drivers) that would apply. Would a source layout putting all the code under drivers/cisco be acceptable in this case, or do I need to move things around and spread out the Kconfig entries across directories? I note that a single drivers/cisco would simplify any related modifications to MAINTAINERS as well.