Hi People!, How are you doing? I write to you because I'm writing a driver for a Realtek8139D 10/100Mbps, just for fun and for practice my knowledge. I spent some time reading about PCI specifications, but I have some doubts about that: 1- I/O Port or I/O memory mapping ( RTL8139 has BAR0 for I/O PORT and BAR1 for I/O Memory ) * I've read about the diferences, and since I understood, the best way to do is with memory mapping. I/O PORT has some limitations like limited instructions can be used. Do you know more about that? More diferences? 2- DMA and memory region * When I request for the I/O memory region of pci device: memr_start = pci_resource_start(dev, IO_MEM); memr_end = pci_resource_end(dev, IO_MEM); The memr_start is the address for reach the device and send data to him? * I've seen that pci_bus_master is supported by RTL8139D: pci_set_master(dev); pci_read_config_word(dev, 0x4, &is_master); pr_info("PCI_BUS_MASTER: %d\n", is_master); it returns 111b, so it can be enabled. Then I think I should call pci_alloc_consistent() to take a DMA address. This DMA address is the address of the BUS (where device is). This should be the address that I have to use for incoming/outgoing data from/to the device? I'm a little bit stuck in these terms Could you help me? Best Regards Oscar