Hello everyone I want to be able to send 1-2KB of data from host, using BARs of a PCIe device, with very low latency. I am working on an FPGA project in which I have to send packet data from Host to FPGA over PCIe 3.0 interface. This is a latency critical application and therefore I want to use BARs to send data in bursts and not use DMA because it has a lot of overhead. I started out with the device driver provided to me by my FPGA board vendor. That driver allocates 'uncached' memory for the BAR via mmap and provides its virtual pointer to the user application for use. When I initiate a transfer by dereferencing that pointer in my application and observe the write signals that arrive at my FPGA using a logic analyzer. I see all write requests arriving after constant time period and the burst count signal is always 1. I have concluded that these transfers are not in bursts. I modified the driver by using the ioremap_wc() on the physical address of BAR and then passed the virtual pointer it returned to set_memory_wc() (apparently I have to use both). I was able to get 'write combined' memory for the physical BAR address. When I do writes using this pointer and observe from logic analyzer I can see burst transfers. That is, I see 4 bursts of 5-6 write requests sent within a short time period. The problem is that the pointer to this memory is a kernel virtual pointer. I want to be able to do the above from user space. How can I do this? Thanks Ankit