udoo - Kernel upgrade using 3.10.17 kernel.

[Anand Moon]

Hi All,

I am trying to update the kernel of the udoo board 3.10.17.
Original kernel supported by Udoo works fine. 

I am able to build the kernel and load the image on the board. 
But is stuck at the boot loader... with following message below.

I think this is bootloader problem ?
If not what could be the problem for the booting of the kernel image to stop.
Is it related to device tree file. 

Please share some pointer so that I can work on to resolve the problem.

------------------------boot message-------------------------------------------

U-Boot 2013.10-rc3 (Jan 20 2014 - 13:33:34)

CPU:   Freescale i.MX6Q rev1.2 at 792 MHz
Reset cause: POR
Board: UDOO
DRAM:  1 GiB
MMC:   FSL_SDHC: 0
*** Warning - bad CRC, using default environment

No panel detected: default to LDB-WVGA
Display: LDB-WVGA (800x480)
In:    serial
Out:   serial
Err:   serial
Net:   using phy at 6
FEC [PRIME]
Warning: failed to set MAC address

Hit any key to stop autoboot:  0 
mmc0 is current device
** File not found boot.scr **
5077712 bytes read in 419 ms (11.6 MiB/s)
Booting from mmc ...
** File not found imx6q-udoo.dtb **
## Booting kernel from Legacy Image at 12000000 ...
   Image Name:   Linux-3.10.17-80552-gd6e35d0
   Image Type:   ARM Linux Kernel Image (uncompressed)
   Data Size:    5077648 Bytes = 4.8 MiB
   Load Address: 10800000
   Entry Point:  10800000
   Verifying Checksum ... OK
   Loading Kernel Image ... OK

Starting kernel ...

-------------------------------------------------------------------------


Please share your thought on this.
-Anand Moon