hd controller

[Peter Teoh]

good sharing.   following up on your comments:

in the kernel source:

block/*.c are the files for block I/O related stuff - the layer just before
ATA, implementing stuff like elevator I/O etc.
drivers/block/*.c:  hardware-specific files that understand how to talk to
each type of harddisk.
drivers/scsi/*.c:   generally SCSI protocol related stuff (lib*.c), but may
contain device specific stuff.
drivers/ide/*.c:
drivers/ata/*.c:   among the lowest level just before sending out port I/O
operation.

On Fri, Feb 8, 2013 at 8:26 AM, <Valdis.Kletnieks at vt.edu> wrote:

> On Fri, 08 Feb 2013 07:48:39 +0800, Peter Teoh said:
>
> > So the drivers just literally concatenate these command into a string and
> > send it over to the device.
>
> The reason that good disk drivers are hard to write is because it isn't
> *just* literally concatenating the commands - it also has to do memory
> management (make sure that everybody's data ends up in the right buffers),
> command queue management, elevator management (if there's multiple I/O
> requests pending from userspace, what order do we issue them in?), error
> recovery, power management, and a ton of other stuff...
>



-- 
Regards,
Peter Teoh
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.kernelnewbies.org/pipermail/kernelnewbies/attachments/20130208/4281ba0b/attachment.html