Is my rootfs correctly mounted?

[Rahul Bedarkar]

yes root file system is mounted correctly. It is just it didn't find init.

On Thu, Aug 30, 2012 at 8:10 PM, stl <st.lambert02 at gmail.com> wrote:
> Hello all,
> if I try to boot Linux 2.6.37 by supplying a configuration file to the
> kernel to create initramfs_data.cpio,
> (without any compression), is it normal that the kernel doesn't print the
> well known message:
>
> VFS: Mounted root (<type> filesystem)
>
> even if the boot reaches the point where it tries to run init executable?
> Does it mean that my rootfs is not correctly mounted?
>
> Here is the kernel output printed during the boot:
>
> <5>[    0.000000] Linux version 2.6.37+ (gcc version 4.6.3 20120816 (GCC) )
> #57 Thu Aug 30 12:00:00 CEST 2012
> [    0.000000] Built 1 zonelists in Zone order, mobility grouping off.
> Total pages: 2032
> [    0.000000] Kernel command line:
> [    0.000000] PID hash table entries: 32 (order: -5, 128 bytes)
> [    0.000000] Dentry cache hash table entries: 1024 (order: 0, 4096 bytes)
> [    0.000000] Inode-cache hash table entries: 1024 (order: 0, 4096 bytes)
> [    0.000000] Memory: 7656k/8196k available (1098k kernel code, 536k
> reserved, 2096117k data, 12k init)
> [    0.000000] SLUB: Genslabs=15, HWalign=16, Order=0-3, MinObjects=0,
> CPUs=1, Nodes=1
> [    0.000000] NR_IRQS:64
> [    0.000000] Timer start: timer interrupt every 10 ms
> [    0.000000] console [ttyS0] enabled
> [42949372.980000] Calibrating delay loop... 0.00 BogoMIPS (lpj=0)
> [42949373.180000] pid_max: default: 32768 minimum: 301
> [42949373.200000] Security Framework initialized
> [42949373.210000] Mount-cache hash table entries: 512
> [42949373.260000] khelper used greatest stack depth: 7548 bytes left
> [42949373.340000] kworker/u:0 used greatest stack depth: 7324 bytes left
> [42949373.500000] bio: create slab <bio-0> at 0
> [42949373.630000] kworker/u:0 used greatest stack depth: 7260 bytes left
> [42949374.630000] kworker/u:0 used greatest stack depth: 7180 bytes left
> [42949375.250000] VFS: Disk quotas dquot_6.5.2
> [42949375.270000] Dquot-cache hash table entries: 1024 (order 0, 4096 bytes)
> [42949375.390000] msgmni has been set to 16
> [42949375.420000] Block layer SCSI generic (bsg) driver version 0.4 loaded
> (major 253)
> [42949375.430000] io scheduler noop registered
> [42949375.440000] io scheduler deadline registered
> [42949375.460000] io scheduler cfq registered (default)
> [42949375.490000] Architecture Specific Serial Driver
> [42949375.500000] ttyS0 at MMIO 0x40001000 (irq = 5) is a arch_uart
> [42949375.700000] loop: module loaded
> [42949375.720000] mice: PS/2 mouse device common for all mice
> [42949375.780000] ------------[ cut here ]------------
> [42949375.800000] WARNING: at fs/proc/generic.c:589 .LBE364+0x0/0x2()
> [42949375.810000] proc_dir_entry '/proc/schedstat' already registered
> [42949375.820000] Modules linked in:
> [42949375.830000] ---[ end trace 31baa4bbf69a8bbc ]---
> [42949375.850000] Failed to execute /init
> [42949375.870000] Kernel panic - not syncing: No init found.  Try passing
> init= option to kernel. See Linux Documentation/init.txt for guidance.
>
> In my opinion, it seems to be correct because the following message doesn't
> appear:
>
> Warning: unable to open an initial console
>
> This means that the file /dev/console has been found, so that the rootfs has
> been correctly mounted, isn't it?
>
>
> Thanks in advance for your help!
>
>
> _______________________________________________
> Kernelnewbies mailing list
> Kernelnewbies at kernelnewbies.org
> http://lists.kernelnewbies.org/mailman/listinfo/kernelnewbies
>